Steel mills

 

WORKING UNDER EXTREME HEAT 


Rockwheel cutting units are perfect for the precise profiling of the interior surface of cauldrons or boliers at steel mills, removing both projections as well as residues. Cutting units are able to withstand the residual heat in cauldrons better than any other conventional attachments, and in contrast to hammers are able to precisely profile boilers without punching any holes into the boiler wall.

Every time oil, gas, or solid fuels such as coal, wood, or steel are burned, residues such as ash, soot, sludge, and slag are produced. These residues settle inside the boiler and need to be removed.

Any soot or limescale soiling on heating surfaces will reduce the boiler’s efficiency and increase fuel consumption, resulting in higher energy costs. In fact, in worst-case scenarios there may even be boiler malfunctions or complete breakdowns, so boilers must be cleaned on a regular basis.


THAT ROCKS:

• Precise profiling

• Does not punch holes into cauldron/ boiler walls

• Able to cut extremely hard material

• Heat-resistant

Print

Applications

logo rot weiss

Address / Contact

Rokla GmbH

Hauptstr. 197
74595 Langenburg
Germany

Telefon: +49 79 05 941 99 0
Fax: +49 79 05 941 99 20
E-Mail: This email address is being protected from spambots. You need JavaScript enabled to view it.